3.
SETUP
AC Power
Warning!
For 230V operation, you must use 230V LED par cans.
Figure 1 - AC
V
Not all fixtures have a voltage
select switch. Please be sure to
connect to the proper voltage.
To determine the power requirements for a particular fixture, see the
label affixed to the back plate of the fixture or refer to the fixture’s
specifications chart. A fixture’s listed current rating is its average current
draw under normal conditions. All fixtures must be powered directly off a
switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel is used solely for a 0% to
100% switch. Before applying power to a fixture, check
that the source voltage matches the fixture’s
requirement. Check the fixture or device carefully to
make sure that if a voltage selection switch exists that
it is set to the correct line voltage you will use.
Warning!
Verify that the voltage select switch on your
unit matches the line voltage applied. Damage to your fixture
may result if the line voltage applied does not match the
voltage indicated on the voltage selector switch. All fixtures
must be connected to circuits with a suitable Earth Ground.
Warning!
All fixtures must be connected to circuits with a suitable Earth
Ground.
LED-PAR 38 System™ User Manual
5
6/24/2008 3:39 PM
