Introduction
Congratulations on the purchase of your new CHAUVET lighting effect. We are confident that you will be
pleased with your purchase. To assist you with the care and use of this product we have prepared a short
guide.
General Setup
Before connecting this unit to the main power supply, you must first install the lamps.
Installing Lamps
1) Locate and remove the Lamp Replacement Set Screws located at the bottom of the lens.
2) Locate two bulb sockets (Ceramic rectangles with 2 holes in each)
3) Remove bulbs from packages, being careful not to touch them with your fingers. Use a napkin
or other clean cloth instead.
4) Place the two prongs on each bulb into the corresponding holes located in the bulb socket.
Apply pressure to get the bulb to seat correctly in the holes.
5) Once both bulbs are in, close cover and replace cover set screws.
This lighting effect has been designed to function on a main power supply of 120V~60Hz or 230V~50Hz and
has been fitted with a suitable power plug. The unit is equipped with a switchable power supply located on
the right hand side of the unit, check the voltage selector switch and verify it is set correctly for your local
voltage.
The Kinta (DMX-311X) is a one-channel DMX fixture that can be blacked out with the
complimentary CH-X controller or programmed with Chauvet's DMX-6, DMX-40, DMX-50, ShowXpress Plus,
X-Factor, or any other universal DMX controller.
Stand Alone
To operate in stand alone mode, no set-up is necessary. Just plug it in and it will react to sound.
Linkable Mode
To operate in Linkable mode, you must link the units together using a premium quality 3-pin DMX cable in
the following configuration. "Out" from the first unit to "In" on the second, "Out" from the second unit to "In"
on the third, and so on. The first unit must have dip switch (10) in the ON position. The
rest of the units must have all dip switches in the OFF position.
At Rear
¥DMX In
¥DMX Out
¥Microphone
¥Remote Input
¥Voltage Selector Switch
¥Dip Switches
¥ Complimentary
blackout controller
Front
¥ Hanging bracket
¥Lamp Replacement
Cover Set Screws
