Hurricane™ Haze User Manual
6
4/20/2010 4:41 PM
Hanging Clamp
Note!
Clamp is sold separately.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
3.
S
ETUP
Fuse Replacement
With a flat head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.
Mounting
Orientation
This fixture may be mounted in a hanging or sitting position, provided there is adequate room for
ventilation.
Rigging
It is important never to obstruct the vents pathway. Mount the fixture using,
a
suitable “C” or “O” type clamp.
When selecting installation location, take into consideration fluid
replacement, access, and routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
4.
O
PERATING
I
NSTRUCTIONS
DMX Mode
This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the
“DMX Primer section” in the Appendix of this manual.
1)
This fixture will automatically switch to DMX mode, once a DMX controller has been plugged into
the 3-pin DMX input.
2)
Use DIP switches 1~9 to set the DMX address.
DMX Channel Values
C
HANNEL
V
ALUE
F
UNCTION
1
000
255
Haze output
0%
100%
2
000
255
Blower/fan speed
0%
100%
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
