Page 12 of 31
ÉPIX Flex Drive User Manual Rev. 1
Operation
Port Setup
To access the settings for Output 1 or Output 2, follow the instructions below.
1. Press
<MENU>
repeatedly until
3.Port Setup
is selected.
2. Press
<ENTER>
.
3. Use
<UP>
or
<DOWN>
to select
1.Output 1
or
2.Output 2
.
4. Press
<ENTER>
.
Start Address
To set the starting address for either port of the ÉPIX Flex Drive, do the following:
1. Navigate to the
for the desired port.
2. Use
<UP>
or
<DOWN>
to select
1.DMX Start Address
.
3. Press
<ENTER>
.
4. Use
<UP>
or
<DOWN>
to increase or decrease the starting DMX address for the selected port,
from
1–496
5. Press
<ENTER>
.
Network Universe
Each ÉPIX Flex Drive uses 6 consecutive universes in Art-Net™ mode and sACN mode, which are
assigned by setting the starting (lowest-numbered) universe address.
To set the starting universe for either port, follow the instructions below.
1. Navigate to the
for the desired port.
2. Use
<UP>
or
<DOWN>
to select
2.Network Universe
.
3. Press
<ENTER>
.
4. Use
<UP>
or
<DOWN>
to increase or decrease the lowest consecutive universe for the selected
port, from
000–256
.
5. Press
<ENTER>
.
LED Quantity
This setting specifies the number of LEDs connected to each port of the ÉPIX Flex Drive. The automatic
programs are scaled according to the value selected in this setting. To change this setting, do the
following:
1. Navigate to the
for the desired port.
2. Use
<UP>
or
<DOWN>
to select
3.LED Quantity
.
3. Press
<ENTER>
.
4. Use
<UP>
or
<DOWN>
to increase or decrease the number of LEDs connected to the selected
port, from
1–960
. (Each ÉPIX Flex 20 has 240 LEDs. 2 ÉPIX Flex 20 products will have 480, 3 will
have 720, and 4 will have 960.)
5. Press
<ENTER>
.
IP Mode
The IP address of the ÉPIX Flex Drive can be set automatically or manually. To configure the IP mode,
follow the instructions below.
1. Press
<MENU>
repeatedly until
4.Set IP Mode
is selected.
2. Use
<UP>
or
<DOWN>
to select either
1.Manual IP
or
2.Static IP
.
3. Press
<ENTER>
.
4. If
1.Manual IP
was selected, use
<UP>
or
<DOWN>
to increase or decrease the selected number
in the IP address, from
0–255
.
5. Press
<ENTER>
.
6. Repeat steps 4 and 5 until the IP address is set as desired.
Netmask
To set the netmask of the ÉPIX Flex Drive when in Manual IP mode, do the following:
1. Press
<MENU>
repeatedly until
5.Set Netmask
is selected.
2. Use
<UP>
or
<DOWN>
to select from
A. 255.000.000.000
,
B. 255.255.000.000
, or
C. 255.255.255.000
.
3. Press
<ENTER>
.
The DMX Start Address for Output 2 only affects the 34 Channel and Pixel personalities.
Summary of Contents for EPIX Flex Drive
Page 1: ...User Manual ...
