Page 2 of 31
ÉPIX Flex Drive User Manual Rev. 1
Before You Begin
Safety Notes
Read all the following safety notes before working with this product. These notes contain important
information about the installation, usage, and maintenance of this product.
Personal Safety
•
Avoid direct eye exposure to the light source while the product is on.
•
Always disconnect the product from the power source before cleaning or replacing the fuse.
•
Always connect the product to a grounded circuit to avoid the risk of electrocution.
•
Do not touch the product’s housing when operating because it may be very hot.
Mounting and Rigging
•
This product is for indoor use only! To prevent risk of fire or shock, do not expose this product to
rain or moisture. (IP20)
•
CAUTION: When transferring product from extreme temperature environments, (e.g., cold truck to
warm, humid ballroom) condensation may form on the internal electronics of the product. To avoid
causing a failure, allow product to fully acclimate to the surrounding environment before connecting
it to power.
•
Mount this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent
surfaces.
•
Make sure there are no flammable materials close to the product when operating.
•
When hanging this product, always secure to a fastening device using a safety cable.
Power and Wiring
•
Always make sure you are connecting the product to the proper voltage in accordance with the
specifications in this manual or on the product’s specification label.
•
Never connect the product to a dimmer pack or rheostat.
•
Never disconnect this product by pulling or tugging on the power cable.
Operation
•
Do not operate this product if there is damage on the housing, lenses, or cables. Have the damaged
parts replaced by an authorized technician at once.
•
Do not cover the ventilation slots when operating to avoid internal overheating.
•
The maximum ambient temperature is 113 °F (45 °C). Do not operate the product at higher
temperatures.
•
The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
•
The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower
temperatures.
•
In the event of a serious operation problem, stop using this product immediately!
Expected LED Lifespan
Over time, use and heat will gradually reduce LED brightness. Clustered LEDs produce more heat than
single LEDs, contributing to shorter lifespans if always used at full intensity. The average LED lifespan is
40,000 to 50,000 hours. To extend LED lifespan, maintain proper ventilation around the product, and limit
the overall intensity.
This product contains no user-serviceable parts. Any reference to servicing in this User
Manual will only apply to properly trained, certified technicians. Do not open the housing
or attempt any repairs.
All applicable local codes and regulations apply to proper installation of this product.
If your Chauvet product requires service, contact Chauvet Technical Support.
Summary of Contents for EPIX Flex Drive
Page 1: ...User Manual ...