EN
2
ÉPIX Flex 20 QRG Rev. 3
QUICK REFERENCE GUIDE
Overview
Power
This product is powered by an ÉPIX Flex Drive. Refer to the ÉPIX Flex Drive User Manual for detailed instructions on how
to connect this product to power.
Mounting
Before mounting this product, read the
. Use 1 of the included brackets every 1.6 ft (0.5 m).
Mounting Diagram
Cutting to Length
Each ÉPIX Flex 20 can be cut to length to accommodate custom installations. Any ÉPIX Flex 20 that is cut to length must
be used as the last product linked to an output port of the ÉPIX Flex Drive.
Termination Kit
After cutting an ÉPIX Flex 20 to length, seal the included end cap to the exposed end of the product with the included
silicone glue:
•
DISCONNECT the product from power before cutting to length.
•
DO NOT cut across electrical components.
•
Any ÉPIX Flex 20 that is cut to length must be used as the last product linked to an output port of
the ÉPIX Flex Drive.
1. Disconnect the product from power.
2. Apply the silicone glue to the exposed end of the product.
3. Insert the exposed end of the product into the end cap.
4. Wipe away any excess glue.
5. Allow to dry before reconnecting to power.
The end cap must be sealed completely to maintain the IP67 rating of the product.
Data/Power
In
Data/Power
Out
End Plug
Seals last linked product
to maintain IP67 rating
Bracket
Insert Screws Here
ÉPIX Flex 20
DO NOT Cut Here
Cut
Here