3. Setup
8
2/6/2012 2:58 PM
Do not use a tool on
the bracket
adjustment knob
Double-yoke
bracket
Single-yoke
brackets (2)
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
Fuse Replacement
1.
With a flat head screwdriver wedge the fuse holder out of its housing.
2.
Remove the damaged fuse from its
holder and replace with exact same type
fuse.
3.
Insert the fuse holder back in its place
and reconnect power.
Mounting
Orientation
The COLORband™ RGB may be mounted in any safe position, provided there is adequate room for
ventilation.
Rigging
Be sure that the structure can support the weight of the fixture. Please see the “Technical
Specifications” section of this manual for a detailed weight listing. Mount the fixture securely. This
may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm in
size. When rigging consider routine maintenance and control panel access. Please see the following
steps for installation.
•
If the power link out is intended to be used with multiple fixture, take into account the length
of each power cable, and mount the fixtures close enough to one another to accommodate
for this.
•
When aiming the fixtures, you may use the bracket adjustment knob. Loosen the knob,
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
•
There are 2 different styles of brackets which are included with this fixture. There is a
single, double-yoke bracket, which is located in the center, rear of the fixture. There are
also 2 single yoke brackets, located on either side of the fixture. These may be used for
floor standing purposes (uplighting) or for mounting with clamps.
•
Safety cables must always be used.
•
2 clamps, one on either bracket, must be used if using the two single-yoke brackets.
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.