Chauvet COLORado Panel Q40, User Manual, Page: 14 / 24

Page 10 of 20
Operation
COLORado Panel Q40 User Manual Rev. 1
Configuration (DMX)
Use control configurations to operate the product with a DMX controller. See Wireless Operation for
instructions on configuring the product for wireless DMX.
Control Personalities
This setting allows you to choose a particular control personality.
1. Go to the DMX Channel main level.
2. Select the desired personality (see table below).
Starting Address
Each product will respond to a unique starting address from the DMX controller. All products with the same
starting address will respond in unison.
1. Go to the DMX Address main level.
2. Select the starting address ( 001 – 509 ).
The highest recommended starting address for each DMX mode is as follows:
Wireless
Setting
Receive On/Off
On
Enables/disables wireless DMX
Off
Receive Reset
No
Resets wireless DMX receiver
Yes
Back Light
On Display backlight always on
10S
Turns off display backlight after 10 seconds
of inactivity
20S
Turns off display backlight after 20 seconds
of inactivity
30S
Turns off display backlight after 30 seconds
of inactivity
Key Lock
On
Locks display (password is <UP> , < DOWN> ,
<UP> , <DOWN> , <ENTER> )
Off
Information
Fixture Hours <_ _ _ _H> Shows total hours the product has been on
Version <V_._> Shows current firmware version
UID <_ _ _ _ _ _ _> Shows product UID
Battery <_ _ _%> Shows remaining battery power
Reset
Factory
No
Resets the product to factory default settings
Yes
Personality Channels
4Ch 4
7Ch 7
11Ch 11
16Ch 16
23Ch 23
• See the Starting Address section for the highest starting address you can select for each
personality.
• Make sure that the starting addresses on the various products do not overlap due to the
new personality setting.
Personality Address
4Ch 509
7Ch 506
11Ch 502
16Ch 497
23Ch 490
Main Level Programming Levels Description