Chauvet COLORado Deco Quad 1 Tour, User Manual

Page: 12 / 21

Operation
-8- COLORado™ Deco Quad 1 Tour User Manual Rev. 1
4. Operation
Control Panel
Description
Button Function
<MENU> Enables the currently displayed menu, sets the currently
selected value into the selected function or exits from the
current menu or function
<UP>
Navigates upward through the menu list and increases the
numeric value when in a function
<DOWN>
Navigates downward through the menu list and decreases the
numeric value when in a function
Control Options You can set the COLORado™ Deco Quad 1 Tour start address in the 001~512 DMX
range. This enables control of up to 51 products in the 9-channel TOUR personality.
Programming
Refer to the Menu Map to understand the menu options. The menu map shows the main
level and a variable number of programming levels for each option. Select oUt or
<MENU> to exit back to the main menu.
DMX Personality
This setting allows you to choose a particular DMX personality.
1. Go to the PEr main level.
2. Select the desired personality ( tor , A1 , A1.d , A2 , A2.d , A2.S , or hSU ).
• See the DMX Values section for the highest starting address you can select for
each personality.
• Make sure that the starting addresses on the various products do not overlap
due to the new personality setting.
DMX Control In this mode, each product will respond to a unique starting address from the DMX
controller. All products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
DMX Personality .
2. Set the running mode:
a. Go to the rUN main level.
b. Select the 512 programming level.
3. Set the starting address:
a. Go to Add main level.
b. Select the starting address ( 001~512 ).
Loss of Signal Setting
This setting controls how the product will respond when the DMX signal is lost.
1. Go to the SEt main level, then select drr .
a. Select SAU to make the product use the last command used when the signal
is lost.
b. Select
bLA
to turn off the all the LEDs when the signal is lost.
Static Color The Static Color mode allows for permanent RGBW color mixing without a DMX
controller.
1. Go to the StA main level.
2. Select the desired color ( rED , grN , BLU , or ytE ).
3. Select the desired color value ( 000 ~ 255 ).
4. Repeat for the other colors.
5. Select Str .
6. Select the desired frequency ( 00 ~ 20 ).