Chauvet Professional W-DMX Micro T-1 TRX G5, User Manual

Page: 9 / 15

Page 6 of 12 W-DMX Micro T-1 TRX G5 User Manual Rev. 1
Operation
4. Operation
User Interface
This section explains the labels and information on the W-DMX Micro T-1 TRX G5 user interface (see also
Introduction section).
Label Description
SIGNAL
Shows whether the W-DMX Micro T-1 TRX G5 is receiving/sending a
signal or not
Signal bars
On a transmitter , indicates the power output in mW:
• Full bar – 475mW
• 2 green LEDs – 375mW
• 1 green LED – 100mW
• Yellow LED – 25mW
• Red LED – no signal
On a receiver , indicates signal strength
BATTERY Indicates battery life of the W-DMX Micro T-1 TRX G5
TX W-DMX Micro T-1 TRX G5 is operating as a transmitter (see Flex Mode )
RX W-DMX Micro T-1 TRX G5 is operating as a receiver (see Flex Mode )
LINK
On a transmitter , indicates it is ready to establish a link
On a receiver :
• Light off – no active link
• Light on – the device is paired to a transmitter
• Light blinking – the device has lost its link (either the transmitter
is out of range or turned off)
(see Linking Devices )
DATA
Indicates whether data is being sent to the transmitter/receiver. If the
LED is off, check if the DMX cable is plugged correctly to the transmitter.
MODE Indicates the radio mode
UNV Indicates double-up mode
PWR Indicates power condition of the device
RDM Indicates whether RDM is active or disabled (see RDM )