Changing The Saw Blade
Take care as the blade teeth are sharp.
Wear protective gloves if necessary.
Unplug the power supply.
Remove the rip fence guide rail by
loosening the fixing bolts underneath
the table.
Open both doors and reduce the blade
tension by turning the tension knob
anticlockwise.
Lower the blade guard fully down.
Slide the blade off the wheels and ease
it out through the slots in the left hand
column, the blade guard and the table.
Reverse these steps to fit the new
blade. Ensure that the teeth are at the
front and pointing down.
If the new blade is a different width,
tension & track the blade first, then
adjust the guide pins and thrust
bearings as shown in this manual.
Troubleshooting
Problem
Cause
Remedy
Machine does not start
Blown Fuse
Replace Fuse
Loose switch terminal
Inspect back of switch
Faulty switch
Replace switch
Only starts when Green
button is held down
Faulty switch
Replace switch
Motor slows down during
operation
Blade is blunt
Replace blade
Feed Speed is Too high
Feed the Work slower, let
the blade do the cutting
Attempting to take too
deep a cut
It may exceed the capacity
of the machine
Machine does not run but
buzzing noise heard from
motor
Failed capacitor
Replace the motor start
capacitor.
