11
Locate the stud into hole at the back right hand
corner of the sliding table.
The bolt should then be passed into the slot
between the two table rails. Fit the washer and
ratchet lever back on. The fence can now be
pivoted to the desired angle, which is reads off the
scale.
The fence can also slide towards and away from
the blade as required.
A retractable stop is located at the back left corner
of the sliding table. Push the slot into the upper
position to locate the fence at 90 degrees.
The stop is mounted into an eccentric dial and can
be adjusted as necessary.
Using the Table Saw
Blade Angle Lock
On/Off Switch
Blade Angle Scale
Cutting Depth Adjuster
Blade Angle Adjuster
Dust Extraction
Connection Point
On/Off Switch
Slide the red section upwards and then lift the hinged cover. This will give you access to the
green start and red stop buttons. Pressing the red section of the cover will stop the saw.
To turn the saw on, press the green button. Wait for the blade to reach its maximum speed
of rotation before commencing with the cut.
