TROUBLE SHOOTING
PROBLEM
SOLUTION
When I light the grill it does not flame
immediately .
--Make sure you have turn on the gas
--Make sure it has spark while you are trying to ignite
the burner.
--Push in for approximately 5 second before to turn
and ignite the grill.
--Make sure your burner is clean.
Rotisseries burner will not light when the
igniter button is pushed.
--Check to see if debris is blocking the electrode
sparks.
--Check to see there is spark that jumps to the burner
from the electrode wire. If no spark is seen.
--Check the battery located inside the button. Press
and turn counter clockwise.
--Check for loose wire connection.
--Gently bend the electrode wire closer to the burner
until a spark is seen to jump from the igniter to the
burner when you press the starter button.
--Dose the infrared back burner light when attempting
to match light? If not, check did you turn on the
gas.
Regulator makes noise.
--Vent hose on the regulator may be plugged or
regulator may be faulty.
--Ensure the vent hole on the regulator is not
obstructed. Clear the hole, close the gas control
valves. Wait ten minutes and re-start.
--Check your flames for proper performance if the
flames are not correct replace regulator.
Full size cover does not fit the grill.
--Cover may be incorrect for your grill. It may be a
tight fit. Ensure the cover correct length for your
grill. Measure it left to right. Compare to the grill’s
measurement.
--Compare the location and size of the hood portion
of the cover to your grill.
--Spread the cover and allow it to relax, preferably in
warm sunlight or in a warm room.
--For grill with a side shelf bunch the cover like a
sock, put on left to right.
16
K15Y06N-1
