CONNECTIONS TO PASSIVE SPEAKER
1.
Screw the two speaker brackets to each of the speakers. Pre-drilled holes are provided.
2.
Select a suitable position for each speaker at either side of the interactive whiteboard.
3.
Fix wall mounting screws into a suitable wall plug position on the wall that speaker will be hung on,
using the central “keyhole” wall mount. Hang the speaker unit on this fixing and mark a hole position on
the wall for the speakers’ top security bracket.
4.
Drill and install a suitable wall plug for the top security bracket.
5.
Connect the 10m speaker cable provided into the active speaker using the RCA connector in the base
of the active speaker. Measure and cut the end of the cable to the length required to join the passive
speaker to the active speaker. Strip off 7mm of insulation from the cut end and insert into speaker con-
nection on the passive speaker. PAY ATTENTION that the passive speaker port cable connection should
be same as below picture.
USAGE OF THE IR REMOTE CONTROLLER
6.
Hang the speakers using the central “keyhole” wall mount and secure the speaker to the wall with the
screws provided into the top wall plug position.
7.
Connect the audio cable with RCA connectors into the rear of the active speaker unit and into the
audio sources (or cable termination box if used)
8.
Plug the power cable to the mains supply and press the button to power on the speakers.
9.
Follow the operation institutions on the following page.
Button Icon
Function
To power on/off the speaker
To mute/play speakers
To increase volume
To decrease volume