Charlton & Jenrick INFINITY 480 BF, Owner'S Manual

Page: 5 / 41

www.charltonandjenjick.co.uk 5 LT6935 (ISS 4)
SECTION ONE Important Information(Users Instructions)
INTRODUCTION

The INFINITY 480 BF is an inset or outset room sealed decorative fuel-effect gas appliance.

The INFINITY 480 BF is available in Natural Gas

The INFINITY 480 BF must not be installed into a natural draught flue or chimney.

The INFINITY 480 BF should only be installed and serviced by a competent person i.e. GAS SAFE
registered, in accordance with the GAS SAFETY (INSTALLATION AND USE) REGULATIONS.

The INFINITY 480 BF does not require a chimney, but must be installed against an outside wall.

It is important that the flue terminal is regularly checked and kept clear at all times.

If the terminal is accessible to people (i.e. less than 2m above a walkway, balcony etc.) the terminal
guard must be fitted to prevent access to the flue outlet, which becomes hot when the fire is in use.

As the INFINITY 480 BF is a room sealed appliance (i.e. air for the combustion process is taken from
outside the room) no purpose built ventilation is required.

The INFINITY 480 BF is designed and tested to meet the requirements of the European Standard EN 613.
Consumer Protection Information
As manufacturers and suppliers of heating products, we take every care, as far as is reasonably practicable,
that these products are so designed and constructed as to meet the general safety requirement when
properly used and installed. To this end, our products are thoroughly tested and examined before despatch.
IMPORTANT NOTICE: Any alteration that is not approved by the appliance manufacturer could invalidate
the approval of the appliance, operation of the warranty and could affect your statutory rights.
Health and safety
Notice Important
This appliance could contain some of the materials, indicated below, that could be interpreted as being
injurious to health and safety. It is the users/installers responsibility to ensure that the necessary personal
protective clothing is worn when handling these materials, see below for information.
Artificial Fuels, Mineral Wool, Insulation Material, Refractory/Ceramic Fibres, Glass Yarn - may be harmful
if inhaled, may be irritating to skin, eyes, nose and throat.
When handling
avoid inhaling and contact with skin or eyes. Use disposable gloves, facemasks and eye
protection. After handling wash hands and other exposed parts. If a vacuum is used for cleaning the coals
or cleaning after servicing / installation it is recommended that it be of the type fitted with a HEPA filter.
Disposal of refractory/ceramic materials
. To keep dust to a minimum these materials should
be securely wrapped in polythene and be clearly labelled ‘RCF waste’. These materials are not classified
as ‘hazardous waste’ and should be disposed of at a site licensed for the disposal of industrial waste.