Installation of stove:
Step1:
Unpack and take away
the stove and parts.
Step2:
Put the stove in the required position. Adjust feet
to ensure it is level.
Open the door of the stove and arrange the
vermiculite
,
clear stones
and
imitation logs
on the plastic surface in
a pleasing arrangement of your choice. See Typical Fuel
Bed Arrangement for a guide
OPERATION
This appliance can be operated by both remote control and manual button. Once the
unit has been properly connected to an earthed electrical outlet, turn on the main
switch. A beep should be heard when the power is first applied.
NOTE: To use both remote and manual functions the main on/off switch must be
in ‘on’ position.
Operating by Manual Button
Flame Button
Heater Button
Main Switch
NOTE
：
The flame will always operate when the appliance is turned on.
Main switch
The main switch supplies power to all of the functions of the fireplace. This switch must
be in the “ON” position for any of the functions including the remote to
operate.
Flame button
By pressing the FLAME button, the unit will cycle through four flame effects.
Heater button
Press once turns Fan on, and 10s later Low heat on. (Pilot lights illuminated
●○
)
Press again turns on High heat. (Pilot lights illuminated
●●
)
Press third time turns heat off. 10s later fan off (Pilot lights illuminated
○○
)
There are 3 levels you can cycle through including the OFF setting.