www.charltonandjenrick.co.uk
8
LT6312 (ISS 3)
SECTION TWO Operating the Appliance (user instructions)
Before attempting to operate the appliance check that nothing
has been placed in front of the appliance that may interfere with
the remote sensor operation.
To light the appliance using the remote hand set:
A.
Point the remote control hand set in the direction of the
appliance and simultaneously press the buttons marked ‘
off’ and ‘standby’. Continue to hold in these two
buttons until a ‘bleep’ is heard (approximately 2-3 sec.)
and then release these buttons. The appliance will
automatically go through the ignition sequence and the
pilot should ignite. Once the pilot is alight the appliance
will automatically go to the high setting (approximately
20-25sec). If the ignitor stops sparking and the pilot fails
to light, repeat this procedure.
B.
The appliance can be adjusted up or down by pressing the appropriate button
'
'
(low setting) or
'
'
(high setting).There are 5 heat settings and the fire will give a double bleep when the maximum or
minimum heat setting is reached. To switch off the appliance press the OFF
'
'
button or if the appliance
is to be switch off for a short period it is recommended that the ‘standby’ button be used. This switches
the main burner off but leaves the pilot on and will extend battery life.
C.
The appliance can be switched off with out using the hand set by removing the appliance batteries
located behind the ash pan cover. When the batteries are removed there will be a delay (up to 3minutes)
after which double bleeps may be heard and shortly after the appliance will extinguish. Ensure that the
battery is reconnected once the fire as been extinguished. The appliance cannot be operated without the
use of the handset. If the fire fails to light or extinguishes for any reason, it will be necessary to re-set the
fire. This can be done by pressing the OFF button then following the normal lighting procedure.
NOTE: If the fire is extinguished for any reason wait 3 minutes before relighting.
