Chariot Chariot Scrubber 10061090, Operating Instructions Manual

Page: 21 / 144

MACHINE OPERATION
86317500 CHARIOT SCRUBBER 11/15/08
3-14
FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off machine
and remove key.
1. Turn the machine power off.
2. Remove solution cover.
3. Fill the solution tank with clean water, leaving
enough room for the required amount of
cleaning solution. The solution tank capacity
filled to fill inlet is 25 gallons (95 liters). The
water must not be hotter than 140
°
F (60
°
C) to
prevent damage to the tank.
4. Measure the chemical into the solution tank.
The solution cover is also a 2 oz. (60 ml)
measuring cup. Liquid chemicals should be
added to the solution tank after filling with water.
Dry chemicals should be thoroughly mixed
before being added into solution tank.
Commercially available, high alkaline floor
cleaners, are suitable for use in the
solution
system.
NOTE: Read the chemical manufacturers
recommended proportion instructions.
5. Replace solution tank cover.
Flammable materials
can cause an
explosion or fire. Do not use flammable
materials in the tanks.
NORMAL SCRUBBING
Plan the scrubbing pattern in advance. The longest
track is around the perimeter of the area to be
cleaned. For efficient operation, the runs should be
the longest possible without turning, stopping, or
raising or lowering scrub deck/squeegee.
In order to achieve the best possible results, the
area which is to be cleaned should be swept before
scrubbing. Large debris, strings and wire must be
removed to prevent being caught in brushes or
squeegee.
If the machine is allowed to stand in neutral with the
scrub deck down for more than 2 seconds, the
solutions flow stops and brush motors stop. If either
forward or reverse travel is selected, the solution
flow will continue in the same setting and the scrub
brush motors will continue in their same setting once
movement of machine begins. Overlap the brush
path and avoid transporting over previously cleaned
areas.