3S-16S LiPolymer battery Monitor and Saver BM16LP V2.0
www.chargery.com
page 4 total 5
Specifications:
Battery range: 3S-16S LiPolymer battery pack
Over discharge warning cell voltage:
2.80~4.20V
step 0.05V, default 3.00V
Over charge warning voltage:
3.90
~
4.30V
per
cell,
step 0.05V, default 4.25V
Delay time when start to warnning:
2S
Warning time:
20S
per period
Accurate scope of the cell voltage:
-5mV/+5mV
Cell voltage display range:0.50V~4.99V, NO
display when under 0.50V
Temperature display range:0.0
℃
~99.9
℃,
Display 0.0 when under 0.0
℃
Display 99.9 when over 100
℃
SOC indicator:
RED area @ 0~15% of SOC
YELLOW area @ 16~35% of SOC
GREEN area @ 36~100% of SOC
Pins distance: 2.54mm
Size:70*65*11 (L*W*T, mm)
Weight: 30g
Warning LED: 11000mCd, @ 2.0V, 20mA
Warning beeper: 85dB @ 12V, 25mA
Package: transparent heat shrink tube or
Customized AL alloy case
Program setup
Before driving your e-bike or e-scooter etc., you can set up many important parameters prevent your
battery from over charge or discharge or over temperature.
1.
Connect your battery to BM16LP
2.
Press SET button for 3 seconds enter into Program Setup menu.
3.
Press UP or DOWN button select the item, press SET shortly make the value flash, and press UP
or DOWN change the value. Press SET button shortly confirm the change. After finish all setup,
press SET for 3 seconds quit the setup menu.
4.
Over charge warning voltage range is
3.90~4.30V per cell,
step 0.05V,
default 4.25V
. During
charge, when any cell voltage over the value, the unit will alarm.
5.
Over discharge warning voltage range is
2.80~4.20V
step 0.05V,
default 3.00V
. During driving,
when any cell voltage under the value, the unit will alarm.
6.
Battery temperature range is
30~80
℃
℃
℃
℃
step 1
℃
,
default 50
℃
. During driving, when battery
temperature over the value, the unit will alarm.
7.
Battery gauge (SOC) range is
5~90%
step 1%,
default 30%
. During driving, when battery gauge
under the value, the unit will alarm..
8.
LCD back-light time range is
1, 5, 10,20min and always ON,
default 5min
. when LCD back-light
ON time reach setup value, it will turn off, and press any button to resume. Press SET button save
setup and quit setup mode.
9.
When quit setup mode, the device will remember all parameters till next change.
