X610 Series
6 IN-00020 [REV001] 201709
Scale base channel setting
Flip back the scale base and the dip switch is under the rubber stopper, the dip switch has four switches, only Switch 1,
2 and 3 are active for use, Switch-4 is not available. Setting. A switch that is up is on, a switch that is down is off, by
default, all switches are down(off), see illustration below
Tare Setting
Place an empty container on the scale and press
[TARE]
or hand over the
Tare sensor
of remote display. The display
will show a net value of “0”.
To clear the Tare value, press
[TARE]
or pass your have over the
Tare senso
r
with the pan empty.
Auto Off Time Setting
Press and hold
[ON/OFF]
first and press
[TARE]
button
, then release both key
until the display show
Press
[UNIT]
, the display will show
A_OFF
, press
[TARE]
to enter auto off time setting and press
[TARE]
to select auto
turn off time or off this function. And press
[TARE]
and press
[HOLD]
to see
End
to confirm setting.
Tare Sensor Off Setting
Press and hold
[ON/OFF]
first and press
[TARE]
button
, then release both key
until the display show
Press
[UNIT]
, the display will show
, press
[TARE]
to enter tare sensor setting and press
[TARE]
to select on
or off this function. And press
[TARE]
and press
[HOLD]
to see
End
to confirm setting.
MAINTENANCE
Cleaning
Before cleaning, disconnect the power plug from power outlet and remove batteries from the appliance to power off
the both units.
• Clean with a damp cloth and a mild soap or similar agents if necessary, and buffed dry with.
• Do not use any acids, alkalis or strong active solvents to clean the housing or control panels.
Scale Base
Dip-switch setting
Channel-1
Channel-2
Channel-3
