Smokin’ Champ™
10
11
asseMBlY InsTruCTIOns
read all safety warnings and instructions carefully before
assembling and operating your grill.
IMPOrTanT HInT: dO nOT TIGHTen anY nuTs and BOlTs unTIl
GrIll Is FullY asseMBled.
step 1
Assemble Long Legs, Short Legs, and Leg Braces as show below then secure the Leg Braces to one set of Long Leg and
Short Leg with four 1 3/4” Hex Bolts and four Hex Nuts.
step 2
Install Bottom Wire Shelf by placing the four corner hooks inside the hole on each leg then rotate the leg assemblies up
and secure the Leg Braces to the other side of the Long Leg and Short Leg set with four 1 3/4” Hex Bolts and four Hex
Nuts.
Leg Brace
Hex Bolt
Short Leg
Hex Nut
Long Leg
Hex Bolt
Hex Nut
Bottom Wire Shelf
step 3
Lay the cart assembly down with the Long Legs on the floor then install the Wheels and Wheel Axle. On one end of the
Axle insert the Large Cotter Pin into the hole on the Axle and snap in the Hub Cap. Slide one 2/5” Flat Washer and one
Wheel onto the Axle then slide the Axle through the holes on the Short Legs and Bottom Shelf. Complete the assembly by
sliding the other Wheel and 2/5” Flat Washer onto Axle then insert the Cotter Pin and snap on the Hub Cap.
step 4
Attach the Grill Body to the previous assembly cart using four 1 3/4” Hex Bolts and four Hex Nuts. The Bolts must go
through the leg, Grill Body then tighten with the Hex Nuts inside the Grill body.
Hub Cap
Large Cotter Pin
Wheel
Wheel Axle
2/5” Flat Washer
Hex Bolt
Hex Nut
