463822004 • 15
CAUTION
If burner does not light, turn knobs to
, wait 5
minutes, and try again. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidently ignite with risk of injury.
OFF
Match-Lighting
s
Do not lean over grill while lighting.
1. Open lid.
2.
3.
4.
Turn on gas at gas source.
Place lit match into match lighting hole from outside grill
bottom (as shown).
Push in and turn RIGHT knob to IGNITE. Be sure burner
lights and stays lit.
Light left burner by pushing LEFT knob in and turning to
IGNITE.
After Lighting: Turn knob(s) to HIGH for warm-up.
Burner Flame Check
• Light burner, rotate knobs from HIGH to LOW. You should see
a smaller flame in LOW position than seen on HIGH. Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the
.
Troubleshooting Section
HIGH
LOW
Turning Grill Off
Ignitor Check
Valve Check
Hose Check
General Grill Cleaning
• Turn all knobs to
position. Turn gas OFF at gas source.
Press ignitor button rapidly.
"Click" should be heard and spark seen each time between
collector box or burner and electrodes. See
if
no click or spark.
. Knobs lock in
position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to
position then turn back to
position. Valves should turn smoothly.
Before each use, check to see if hose is cut or worn. Replace
damaged hose before using grill. Use only parts specified by
manufacturer.
• Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory
. Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom. Rinse and allow to completely
air dry.
•
Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use nonabrasive scouring powder
for stubborn stains.
Wash with mild detergent or nonabrasive
cleaner and warm soapy water. Wipe dry with a soft
nonabrasive cloth.
• Turn gas off at gas source.
• Important: Make sure gas is off at gas source before
checking valves
LO
•
(and should never be painted)
Do not apply a caustic grill/oven cleaner to painted
surfaces.
Plastic parts:
• Porcelain surfaces:
• Painted surfaces:
"Troubleshooting"
s
OFF
OFF
OFF
Match-lighting hole is
in bottom.
