Page 11
8
7
NOTE: The temperature gauge may be packed inside of
the smokestack to prevent damage during shipping. If so,
remove gauge before assembling smokestack to chamber.
• Insert two
#10-24 X 3-1/2”
screws into handle and place
spacers and fiber washer onto screws on other side of handle.
• Place the handle assembly into the holes on the front of the
smoker chamber door and secure with two
#10-24
flange nuts.
Tighten flange nuts until bolt head is flush with handle.
• Repeat on firebox door.
• Assemble spring handle by sliding spring through handle rod
until spring is in the middle of handle rod as shown in inset.
• Insert spring handle through holes on the side of firebox and
secure with two
1/4-20
flange nuts.
Fully tighten all screws and nuts.
Screw
Handle
Spacer
Fiber
Washer
Nut
Nut
Spring
Handle
Firebox
Handle Rod
Spring
8
• Remove
wing nut
from temperature gauge.
• Insert temperature gauge though smoker chamber lid hole
above handle securing it from the underside with the
wing
nut
removed aligning the gauge settings before fully
tightening.
• Insert logo plate though smoker chamber lid holes to the
right of the handle, securing it from the underside of the lid
with two
logo clips
.
Temperature
Gauge
Logo Plate
Logo Clips
Wing
Screw
