Unpacking and Mounting the BeaconPoint
Chantry Networks Inc.
BeaconPoint Installation Guide
Page 2
Copyright 2003. All rights reserved.
Unpacking and Mounting the BeaconPoint
Unpack the BeaconPoint from its carton.
Also in the carton are the following:
• one wall bracket
• one allen key (to depress security latch)
• one plastic spreading rivet and matching
plastic screw (to secure BeaconPoint to
bracket
1.
Mount the BeaconPoint
wall bracket, using 3 screws. For
a typical dry wall mounting, use #6
X 1 inch pan head sheet metal
screws with # 6 plastic wall
anchors.
Make sure the top of the bracket
is near the LAN ethernet cable
plug coming from the wall.
2.
Press the back of the
BeaconPoint onto the
bracket, aligning it
with the open notches
in the bracket.
Then slide it downwards
until it click into place.
↑
Channel for allen key to
spring clip
Security Note #1:
A small spring clip on the BeaconPoint case has now
snapped into an opening in the bracket. To remove the BeaconPoint
from the bracket, insert the allen key (provided) into a small hole at the
bottom of the bracket. Use the allen key to depress the spring clip. Then
you can slide the case up the bracket and lift off the BeaconPoint.
Opening for rivet
↓
↑
Opening for allen key
3.
Insert the
plastic spreading rivet
through the hole at the bottom of the
bracket and into the BeaconPoint
case. Then screw in the plastic screw.
This spreads the rivet and locks the
case to the bracket.
Security Note #2:
The spreading rivet prevents casual removal of the
BeaconPoint. You will need a screwdriver to remove it.
