The IU-6xxx, and IU-6xxxP come with a mini camera that can be attached to
the integrated mount that allows the camera to see through the opening in
the plate. The illustrations bellow show how to mount the camera.
Attaching the Camera
Mini Pinhole Camera
Mounting Hole
Cone Lens
Connect Telephone Entry Controller here
(see following pages for details)
Connect to power supply
and video distribution system
Remove this
section of screen
material
Attach camera to mount
using the screw provided
Attach pigtail
to rear of
camera
Completed Sub-assembly
(see Attaching the Companion Board)
Break away the section of perforated metal screen that covers the camera
opening by pushing a screwdriver through the slot on the front of the door
plate. Press near the top or bottom of the section and the tabs that hold it in
place will break free. Attach the camera to the mount so that the cone of the
camera points through the opening. Adjust the camera to the desired position
and secure it in place by tightening the screw on the mount.
This door intercom product consists of two sub assemblies which must be
attached to each other before the final assembly can be installed. In this
guide the electronic sub assembly will be referred to as the “Companion
Board” and the mechanical assembly will be referred to as the “Door Plate.”
Review the following diagrams and assemble as shown.
Attaching the Companion Board
Companion Board Connection Details
To Button
To Speaker
Microphone
Companion Board
Place microphone
in this compartment
Place cap over
microphone
Connect Telephone Entry Controller here
(see following pages for details)
Completed Sub-assembly
Attach button and
speaker wires as shown
Attach Companion Board
with mounting screws
Remove the plastic cap that covers the microphone compartment on the
door plate. Place the microphone in the compartment and replace the plastic
cap over the microphone. Note that the plastic cap will form a friction fit over
the top of the microphone wires holding them snug against the outer
compartment wall until they exit at the base as shown. Remove the mounting
screws which are already attached to the bracket and use them to attach the
companion board. The companion board should mount on the front side of
the bracket so that the screws pass through the companion board before
threading into the bracket.
4
5
