IN
OUT
6
4.
Open the slide-out cradle
and dock your iPod.
5.
Enjoy your music!
Slide-out Cradle
Connections:
Trouble?
1) Be sure you have connected the CAT5 cable correctly. Note that the
stripe/solid pattern should match the labels on the product. Miss-wiring
can cause distorted sound or prevent the system from working at all!
2) Be sure you have connected the speakers in phase. Follow the label
on the product. Out of phase speakers can rob the system of its bass,
especially when driving dual-voice-coil speakers.
Connection Tips and Troubleshooting
Input/Output
... To simplify installation, the
A0313 has both 110 and RJ-45 inputs and
outputs. Only one of the inputs and one of the
outputs should be used at a time.
7
Apple and iPod is are trademarks of Apple, Inc., registered in the U.S.
and other countries.
iBus is a registered trademark of Channel Vision Technology.
* When used on runs longer than 150’, upgrading the hub power
supply to 24VDC is recommended. All components in this system are
compatible with 24VDC power.
Stripping and Connecting CAT5 Wire
Specifications:
(typical @25º C)
Operating Voltage :
*18VDC
Cable requirements:
CAT5 or better
Operating Temperature:
-10ºC to +50ºC
Specifications subject to change without notice.
Blade
Cat5
1.
Place the CAT5 between the blade and the first notch of the J-110 tool.
CAT5 cable should be stripped with a proper stripping tool, such as Channel
Vision’s J-110 tool.
Slight
pressure
Rotate
1 turn only
2.
Rotate the tool only once around the CAT5. Multiple
turns will cause you to cut into the inner wires.
3.
Inspect the inner wires for damage.
If any wires are cut start over at step 1.
Check for damage
4.
Use any standard 110 punch-down tool to properly seat all wires.
Note: Do NOT use a screwdriver or any other tool that is not specifically
designed for terminating UTP cable. Using improper tools will damage
the connector!
Support Clips
3.
Select the appropriate support clip for your iPod.
Note: there are 3 support clips provided to
accommodate standard iPods, the iPod mini, and
the iPod nano.
1.
Mount the A0313 in a low
voltage ring or junction box.
2.
Install the trim ring.
Installation
