LED Indications:
PWR LED:
LED
ON indicates Power to the amplifier is ON
Active LED:
Red indicates no audio input - Amplifier is in standby.
Green indicates audio input is present.
Volume Control works only when this LED is green.
Specifications:
Power input:
24VDC, 2.5 amp,
earth ground negative, 3 plug
UL approved transformer
Audio Output:
100 Watts/ 50 Watts x2
OHMS
8 ohms @ <1% THD
Frequency Response:
20-20kHz (+/-3dB)
Signal to Noise Ratio:
>85dB
Subwoofer output frequency
20-80 Hz
Input Sensitivity:
50 mV RMS
Operating temperature:
-8 ~ +130º C
Specifications subject to change without notice
Stripping and Connecting CAT5 Wire
Blade
CAT5
1.
Place the CAT5 between the blade and the first notch of the J-110 tool.
CAT5 cable should be stripped with a proper stripping tool, such as Channel
Vision’s J-110 tool.
Slight
pressure
Rotate
1 turn only
2.
Rotate the tool only once. Multiple
turns could damage the inner wires.
3.
Inspect the inner wires for damage.
If any wires are cut start over at step 1.
Check for damage
