If signal level is weak and time reception is not successful, move the unit away from any source
of possible interference and try again in another location. The R/C clock will attempt a daily
synchronization at 1:00 AM everyday. If not successful, the R/C clock will search for the time
signal every hour. Each R/C reception cycle lasts from 2 to 5 minutes. To avoid interference, the
unit will disable the other button functions during Radio Controlled Time reception. This is not a
defect. Simply press the SET button to turn Radio Controlled Time reception temporarily off.
To Set Clock Manually:
In case the clock is not able to receive the time signal quickly, you can still enter the time
manually.
•
Set desired time zone first ( see above, Entering Time Zone)
•
Hold the SET button for 3 seconds: Press the “+” or “-“ to adjust the setting and press
SET to confirm the setting sequence. The sequence is:
Year/Month/Date/Hour/Minute/12/24hr/DST on/off/Exit
•
DST on/off is the Daylight Saving Time function. ON means it is enabled and OFF means
it is disabled. Even if we are not currently observing DST and you are a state that
observes DST you want to make sure that it is set for ON.
ALARM
Enter the alarm setting mode by pressing and holding the ALARM button for 3 seconds. The
hour digit will begin to flash. Set the required hour by pressing the “+” or “-“ buttons on the
front of the unit. Be sure to pay attention to the proper AM or PM setting to ensure your alarm
will sound at the correct time. Press the alarm button again and the minutes will flash. Set the
correct time using the “+” or “-“ buttons located on the front of the unit. Press the alarm button
again to exit the set up and return the display to the current time.
Activate or Stop Alarm
To activate the alarm you want to press and release the “+” button on the front of the unit. To
stop the alarm, press the ALARM button to stop the alarm for 24 hours. The alarm can also be
silenced by pressing the “+” button on the front of the unit with the bell symbol over it. This will
turn off the alarm until you press this button again to reactivate it.
SNOOZE/LIGHT
Press the snooze/light button to enter the SNOOZE mode. The alarm will sound again in 8
minutes. A green backlight will also illuminate for 3 seconds each time this button is pressed.
Min/Max Memory
Press the “MEMORY” button to view the maximum temperature and humidity values for both in
indoor and outdoor. Press again to view the minimum values. After 5 seconds the display will
return back to the present readings. The Min/Max button will be cleared every night at midnight.
Temperature & Humidity Trends (Outdoor Temperature & Humidity)
If the temperature increases by more then 1 degree or the humidity increases by 3%, the trend
arrow will point up showing a rising trend. If the temperature change is less than 1 degree or
the humidity changes less than 3% the trend arrow will be level showing a steady reading. If the
temperature drops more than 1 degree or the humidity drops 3% the trend arrow will point down
showing an falling trend. Trend icons update every hour.
Moon Phase
The unit will display the current moon phase according to the time and calendar. All phases will
flash once in sequence but the current moon phase will remain displayed for 5 seconds. This
feature requires no adjustment on the user end.
