8
STEP 1: Plumb the system into your water supply
INSTALLATION INSTRUCTIONS
Unpack equipment.
Systems are sized for 1.5”, 2”, or 3” inlet / outlet.
With the bypass loop in bypass position, turn on the main water supply. Open
a cold soft water tap nearby and let run a few minutes or until the plumbing
is free from foreign material (usually solder or debris from cutting the pipe)
that may have resulted from the installation. Once clean, close the water tap.
*
Note: This system is for INDOOR use only. The system may be installed in
any orientation as long as it is configured in the order shown above.
Hub
