For Model Series
FAD242
FAD248
Circle the model of your cooler and record
the serial number below.
Read Carefully All Of This Manual Before
Installing The Unit
Encierre con un circulo el modelo de su
enfriador y escribe el número de serie
abajo.
Lea Con Cuidado Todo Este Manual Antes De
Instalar La Unidad
Serial #
Número de Serie
110497
12-03
High Capacity
Axial Fan
Evaporative Cooler
Owner’s Manual
Table Of Contents
Safety Instructions ......................................................................... 1
Operation ........................................................................................ 1
Installation Instructions .................................................................. 2
Maintenance Section .................................................................... 2-3
Electrical Wiring Diagrams .............................................................. 3
Troubleshooting .............................................................................. 4
Warranty ......................................................................................... 4
General Specifications
(Especificaciones Generales) .....................
5
Motor Specifications
(Especificaciones Del Motor) .......................
5
Parts List - Blower Section
(Lista De Piezas) ............................
6-7
Parts List - Wet Section
(Lista De Piezas) ..................................
8-9
Spanish
(Instrucciones en Español) ...........................................
9-12
Read And Save These Instructions
Safety Rules
1. Read instructions carefully.
2. Disconnect all electrical service that will be used for the unit before
you begin the installation.
3. Electrical hook up should be done by a qualified electrician, so that
all electrical wiring will conform to your local standards.
4. For a maximum safety precaution, make sure cooler cabinet is
properly grounded to a suitable ground connection.
5. Cooler must be connected to proper line current, voltage and cycle,
as stamped on cooler motor and pump motor specification plate.
Operation
To eliminate delivery of hot air when starting cooler, Start the pump
without the blower for the first few minutes, then turn on the blower
motor.
These coolers may be used without water for ventilation purposes.
When outside air is cool (for example, at night) or when humidity is
high the water pump can be turned off.
6. This unit must be installed at a height of 10 feet or greater from the
floor.
7. Always
Disconnect Power
before performing any maintenance.
