![background image](http://html1.mh-extra.com/html/champion/chvs310/chvs310_user-manual_2588966003.webp)
EN
Preparation for use
Preparation for use
Unpacking and set up
1.
Carefully remove the unit from the display carton and remove all packing material from the unit.
2.
Unwind the AC power cord and extend it to its full length.
3.
Unwind the FM Antenna wire and extend it to its full length.
4.
Place the unit on a stable, level surface, convenient to an AC outlet, out of direct sunlight, and away
from sources of excess heat, dust, moisture, humidity or strong magnetic fi elds.
5.
Raise the lid to expose the phonograph. The phonograph has been secured for shipment with a
transit screw. Use a coin or screwdriver to tum the transit screw clockwise. This will allow the
turntable to ”fl oat”.
6.
Remove the opaque white plastic stylus cover from the phonograph stylus by sliding it forward and
down.
7.
Discard the stylus cover.
8.
Remove the twist-tie that was used to secure the tone arm during shipment.
9.
Release the tone arm lock lever.
10.
Connect the plug to your AC outlet.
Transit screw
Tone arm lock lever
Stylus cover
Protect your furniture
This model is equipped with non-skid rubber feet to prevent the product from moving when you operate the
controls. These feet are made from non-migrating rubber material specially formulated to avoid leaving any
marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber feet to soften, and leave marks or a rubber residue on the furniture.
To prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt
pads, available at hardware stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber feet before you place the product on fi ne wooden furniture.
Protect your furniture
Protect your furniture
Protect your furniture
IMPORTANT
Raising and Lowering the Lid:
• To open the lid, raise it as far as it will go until the lid support bracket locks in the open position. To close
the lid, lift it upward slightly until the lid support bracket unlocks, and then gently lower the lid.
• To avoid damaging the cabinet or the lid, never force the lid closed. always raise the lid to release the
lid support bracket.
To save power consumption:
• To help save power consumption, if there is no audio signal input for 20 minutes while the unit is
powered on, the unit will cut off power automatically. To turn power back on and resume playing, you will
need to tum off the power fi rst and tum it back on to continue.
IMPORTANT
2.