Assembly
8
Rev 76553-20100203 - English
Assembly
Your pressure washer requires some
assembly. This unit ships from our factory
without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the
assembly of your pressure washer, call our
help line at 1-877-338-0999. Please have
your serial number and model number
available.
Remove the Pressure Washer
from the Shipping Carton
1.
Set the shipping carton on a solid, flat
surface.
2.
Remove everything from the carton
except the pressure washer.
3.
Carefully cut each corner of the box
from top to bottom.
Add Engine Oil
CAUTION
DO NOT attempt to crank or start the engine
before it has been properly filled with the
recommended type and amount of oil. Damage
to the pressure washer as a result of failure to
follow these instructions will void your warranty.
1.
Place the pressure washer on a flat, level
surface.
2.
Remove oil fill cap/dipstick to add oil.
3.
Add 0.63 qt (0.6 L) of oil and replace oil
fill cap/dipstick.
4.
Check engine oil level daily and add as
needed.
CAUTION
The engine is equipped with a low-oil-shutoff and
will stop when the oil level in the crankcase falls
below the threshold level.
NOTE
Check oil often during the break-in period. Refer
to the Maintenance section for recommended
service intervals.
Add Fuel
1.
Use clean, fresh, regular unleaded fuel
with a minimum octane rating of 85.
2.
DO NOT mix oil with fuel.
3.
Clean the area around the fuel cap.
4.
Remove the fuel cap
5.
Slowly add fuel to the tank. DO NOT
overfill. Allow approximately ¼ inch of
space for fuel expansion.
6.
Screw on the fuel cap and wipe away any
spilled fuel.
CAUTION
Use regular unleaded gasoline with a minimum
octane rating of 85.
DO NOT mix oil and gasoline.
Fill tank to approximately ¼” below the top of
the tank to allow for fuel expansion.
DO NOT fill fuel tank indoors.
DO NOT fill fuel tank when the engine is running
or hot.
DO NOT overfill the fuel tank.
DO NOT light cigarettes or smoke when filling the
fuel tank.
Install the Hoses
Attach the Pressure Gun
1.
Attach the lance with nozzle to the gun.
2.
Connect the high pressure hose to the
outlet connection on the pump.
3.
Connect the other end of the high
pressure hose to the gun.
Connect to Garden Hose
Secure a garden hose (not included) to the
inlet connection on the pump.
