(4)
Repair or replacement of any warranted part under the warranty must be performed at no charge to the
owner at a warranty station.
(5)
Notwithstanding the provisions of Subsection (4) above, warranty services or repairs must be provided
at all CPE approved service centers.
(6)
The owner must not be charged for diagnostic labor that leads to the determination that a warranted
part is in fact defective, provided that such diagnostic work is performed at a warranty station.
(7)
The manufacturer is liable for damages to other engine components proximately caused by a failure
under warranty of any warranted part.
(8)
Throughout the emissions warranty period defined in Subsection (b)(2), the manufacturer must
maintain a supply of warranted parts sufficient to meet the expected demand for such parts.
(9)
Any replacement part may be used in the performance of any warranty maintenance or repairs and
must be provided without charge to the owner. Such use will not reduce the warranty obligations of
CPE.
(10) Add-on or modified parts that are not exempted by the Air Resources Board or the U.S. EPA may not
be used. The use of any non-exempted add-on or modified parts will be grounds for disallowing a
warranty claim. CPE will not be liable to warrant failures of warranted parts caused by the use of a
non-exempted add-on or modified part.
(11) The manufacturer issuing the warranty shall provide any documents that describe that manufacturer's
warranty procedures or policies within five working days of request by the Air Resources Board.
(d)
Emission Warranty Parts List
.
(1)
Fuel Metering System
(i)
Carburetor and internal parts (and/or pressure regulator or fuel injection system).
(ii)
Air/fuel ratio feedback and control system.
(iii)
Cold start enrichment system.
(iv) Fuel
Tank.
(2)
Air Induction System
(i)
Controlled hot air intake system.
(ii)
Intake
manifold.
(iii)
Air
filter.
(3) Ignition
System
(i)
Spark
Plugs.
(ii)
Magneto or electronic ignition system.
(iii)
Spark
advance/retard system.
(4)
Exhaust Gas Recirculation (EGR) System
(i)
EGR valve body, and carburetor spacer if applicable.
(ii)
EGR rate feedback and control system.
(5) Air
Injection
System
(i)
Air pump or pulse valve.
(ii)
Valves affecting distribution of flow.
(iii)
Distribution
manifold.
(6)
Catalyst or Thermal Reactor System
(i)
Catalytic
converter.
(ii)
Thermal
reactor.
(iii)
Exhaust
manifold.
(7) Particulate
Controls
(i)
Traps,
filters,
precipitators, and any other device used to capture particulate emissions.
(8)
Miscellaneous Items Used in Above Systems
(i) Electronic
controls.
(ii)
Vacuum, temperature, and time sensitive valves and switches.
(iii)
Hoses, belts, connectors, and assemblies.
CPE will furnish with each new engine written instructions for the maintenance and use of the engine by the owner.
