background image

40065 - WhEEL KIT

ASSEMbLy

3

ASSEMbLy

 

CAUTION

The wheel kit is not intended for over-the-road use.

Install the Wheels

1.  Drain oil and fuel, and then tip the generator slowly so that 

the engine side is up.

2.  Slide the wheel pin roll through the wheel from 

the outside. (A)

3.  Slide the wheel pin roll through the mount point on the frame. 

(B)

4.  Secure with the R-Pin. (C)

5.  Repeat steps 2-4 to attach the second wheel.

A

C

B

You will need the following tools to install the leg support and 
handle:

 

12mm wrench or adjustable wrench (not included)

 

Socket wrench with a 12mm socket (not included)

Install the support leg 

1.  Attach the rubber vibration mounts to the support leg with a 

flange bolt M8 x 25 and flange lock nuts. 

2.  Attach the support leg to the generator frame with flange 

bolts M8 x 16 and flange lock nuts and fasten securely. DO 
NOT over tighten the lock nuts. (D)

3.  Tip the generator slowly so that it rests on the wheels and 

support leg.

 

NOTICE

Some generator models will require removing rubber pads 
prior to installing the support leg. The support leg will use the 
same holes as the rubber pads.

Install the handle 

1.  Place the handle over the mounting channel on the frame.

2.  Secure the handle to the frame using the two handle bolts.

3.  Place a lock nut on the end of each bolt and fasten securely. 

DO NOT over tighten the lock nuts. (E)

D

E

Summary of Contents for 40065

Page 1: ...ATION MANUAL MODEL 40065 Wheel Kit Made in China REV 20190820 Champion Power Equipment Inc Santa Fe Springs CA USA or visit championpowerequipment com REGISTER YOUR PRODUCT ONLINE at championpowerequipment com ...

Page 2: ...olt M8 x 45 Handle Assembly Flange Bolt M8 x 16 Flange Bolt M8 x 25 Rubber Support Support Leg Qty 2 2 2 6 2 1 2 2 2 1 1 2 3 4 4 5 6 7 8 9 10 Part Number Description Qty 1 2 16 001 R Pin 2 2 122 201701 07 2 Wheel Black 2 3 122 201501 23 Pin Roll Wheel 2 4 1 6177 1 08 Lock Nut M8 Flange 6 5 1 5789 0845 Flange Bolt M8 x 45 2 6 122 200700 01 Handle Assembly 1 7 1 5789 0816 Flange Bolt M8 x 16 2 8 1 5...

Page 3: ...ot included Install the support leg 1 Attach the rubber vibration mounts to the support leg with a flange bolt M8 x 25 and flange lock nuts 2 Attach the support leg to the generator frame with flange bolts M8 x 16 and flange lock nuts and fasten securely DO NOT over tighten the lock nuts D 3 Tip the generator slowly so that it rests on the wheels and support leg NOTICE Some generator models will r...

Page 4: ...e Installation Use and Maintenance This warranty will not apply to parts and or labor if the product is deemed to have been misused neglected involved in an accident abused loaded beyond the product s limits modified installed improperly or connected incorrectly to any electrical component Normal maintenance is not covered by this warranty and is not required to be performed at a facility or by a ...

Reviews: