![background image](http://html1.mh-extra.com/html/champion/100787/100787_operators-manual_2588930015.webp)
100787 - 3500 PSI PRESSURE WAShER
OPERATION
15
NOTICE
Do not run the pressure washer without water supply
connected and turned on, as this may damage the high
pressure seals and decrease pump life. Completely unwind the
hose from its reel or coil and make sure the hose is not being
restricted by tires, rocks, or any other objects that may lessen
or prevent water flow to the pressure washer.
Install the Vented Oil Cap
Before using the pressure washer:
1. Unscrew the shipping plug. A 17mm or 11/16” wrench
(not included) may be used.
2. Remove the vented oil plug from the plastic bag.
3. Screw the vented oil plug into the pump by hand.
Do not overtighten.
Add Engine Oil
Refer to Honda’s engine owner/operator manual.
Add fuel
Refer to Honda’s engine owner/operator manual.
OPERATION
Pressure Washer Location
This pressure washer must have at least 5 ft. (1.5 m) of clearance
from combustible material. Leave at least 3 ft.
(91.4 cm) of clearance on all sides of the pressure washer to
allow for adequate cooling, maintenance and servicing. Place
the pressure washer in a well ventilated area. DO NOT place the
pressure washer near vents or intakes where exhaust fumes could
be drawn into occupied or confined spaces. Carefully consider
wind and air currents when positioning pressure washer.
before Starting the Engine
1. Turn the water supply ON.
2. Pull the trigger on the trigger gun to purge all air from the
pump and hose. This may take several minutes.
3. Do not start the engine until a steady stream of water is
flowing from the nozzle.
CAUTION
Never operate your pressure washer without water.
Starting the Engine
Refer to Honda’s engine owner/operator manual.