![background image](http://html1.mh-extra.com/html/champion/100386/100386_operators-manual_2588929020.webp)
100386 - 4200 PSI PRESSURE WAShER
STORAGE
20
EVERY 100 HOURS OR EVERY SEASON
Change oil
Clean/adjust spark plug
Check/adjust valve clearance*
Clean spark arrester
Clean fuel tank and filter*
EVERY 250 HOURS
Clean combustion chamber*
EVERY 3 YEARS
Replace fuel line*
* To be performed by knowledgeable, experienced owners or Champion Power
Equipment certified dealers.
STORAGE
Refer to the Maintenance section for proper cleaning
instructions.
Pressure Washer Storage
1. Allow the pressure washer to cool completely before
storage.
2. Turn off the fuel supply at the fuel valve.
3. Clean the pressure washer according to the instructions in
the Maintenance section.
4. Store the unit in a clean, dry area out of direct sunlight.
Engine Stored for Less than 30 Days
1. Allow the engine to cool completely before storage.
2. Clean engine according to the Maintenance section.
3. To extend the fuel storage life add a properly formulated
fuel stabilizer to the tank.
4. Ensure the fuel valve is in the “OFF” position.
Engine Stored for Over 30 Days
1. Add a properly formulated fuel stabilizer to the tank.
2. Run the engine for a few minutes so the treated fuel cycles
through the fuel system and carburetor.
3. Turn the fuel valve to the “OFF” position.
4. Let the engine run until fuel starvation has stopped the
engine. This usually takes a few minutes.
5. The engine needs to cool completely before cleaning and
storage.
6. Clean the engine according to the Maintenance section.
7. Change the oil.
8. Remove the spark plug and pour about
1
⁄
2
oz. (14.9 mL) of
oil into the cylinder. Crank the engine slowly to distribute
the oil and lubricate the cylinder.
9. Reattach the spark plug.
Winter Storage
Protect your pressure washer parts from freezing.
1. Apply all storage instructions from previous sections.
2. Make sure pressure washer hose is free of all water before
storing for winter.
3. In order to prevent the pump from freezing you will need to
insert RV antifreeze.
4. You will need approximately 6 oz. (177.4 mL) of RV
antifreeze, a funnel, and approximately 12 in. (30.5 cm) of
garden hose or equivalent. See diagram below.
5. Pour the antifreeze into the funnel, then pull on the engine
recoil starter to create suction in the pump housing. Pull
the recoil several times until antifreeze comes out of the
pump outlet.
WARNING
Never store the pressure washer inside or next to appliances
where there is a source of heat or open flame, spark or pilot
light because they can ignite gasoline vapors.
DO NOT store a pressure washer near fertilizer or any
corrosive material.
Even with an empty gas tank, gasoline vapors could ignite.