13
ENGLISH
92050-1
OPERATION
Before Each Use Inspect the Log Splitter
1. Check the hydraulic oil level and visually inspect all
hoses, attachments and cylinder for leaks, cracks,
fraying or other damage.
2. DO NOT operate the log splitter if there is any
indication of damage or oily residue.
3. Inspect the engine and make sure the oil level is
correct before operating. If the engine is equipped
with a spark arrestor, clean and inspect it regularly
(follow spark arrestor maintenance schedule).
4. The tires need to be fully inflated and in good repair.
Reference the tire sidewall for recommended tire
pressure.
Towing Log Splitter Safety
1. Always check local and state regulations regarding the
requirements for towing, licensing and lights.
2. Before towing make sure the log splitter is correctly
and securely attached to the vehicle and the safety
chains attached with enough slack to allow for turning.
3. Never exceed the max. travel speed of 72 km/h (45
MPH). Towing the log splitter at speeds greater than
72 km/h (45 MPH) could result in serious injury or
death. Always adjust your towing speed according to
the terrain and conditions.
4. Always disconnect the log splitter from the towing
vehicle before operating.
Log Splitter Location
This log splitter must have at least 2.1 m (7 ft.) of
clearance from combustible material. Leave at least
91.4 cm (3 ft.) of clearance on all sides of the log splitter
to allow for adequate cooling, maintenance and servicing.
DO NOT place the log splitter near vents or intakes where
engine exhaust fumes could be drawn into occupied or
confined spaces.
Always operate the log splitter outdoors.
The log splitter needs to be on a dry, level surface with
good footing. DO NOT work on mud, ice, tall grass, brush
or snow.
Only operate log splitter from work zone shown below.
Vertical Operating
Position
Work Zone
Horizontal Operating
Position
Wo
rk
Zo
ne
Log Splitter Location Cont’d.
For Vertical Operation:
– Remove the beam lock-pin from the beam
bracket
– Use handle on cylinder to rotate beam to vertical
position
– Insert beam lock-pin in the pivot bracket
NOTE
DO NOT overinflate tires. Serious injury can result if
tires explode.
DO NOT tow the log splitter if the tires are worn or
will not hold air.
DO NOT exceed the maximum 72 km/h (45 MPH)
towing speed.
WARNING
