Maintenance
Rev 70002-20080214
13
Maintenance
The owner/operator is responsible for all
periodic maintenance.
WARNING
Never operate a damaged or defective pressure
washer.
WARNING
Improper maintenance will void your warranty.
Complete all scheduled maintenance in a
timely manner. Correct any issue before
operating the pressure washer.
NOTE
For service or parts assistance, contact our help
line at 1-877-338-0999.
Engine Maintenance
To prevent accidental starting, remove and
ground spark plug wire before performing
any service.
Oil
Change oil when the engine is warm. Refer
to the oil specification to select the proper
grade of oil for your operating environment.
1.
Remove the oil drain plug with a 15 mm
socket and extension.
2.
Allow the oil to drain completely.
3.
Replace the drain plug.
4.
Remove oil fill cap/dipstick to add oil.
5.
Add 0.63 qt (0.6 L) of oil and replace oil
fill cap/dipstick.
6.
Dispose of used oil at an approved waste
management facility.
Spark Plugs
1.
Remove the spark plug cable from the
spark plug.
2.
Use the spark plug tool that shipped
with your pressure washer to remove the
plug.
3.
Inspect the electrode on the plug. It
must be clean and not worn to produce
the spark required for ignition.
4.
Make certain the spark plug gap is 0.7 -
0.8mm (0.028 - 0.031 in.).
5.
Refer to the spark plug recommendation
chart when replacing the plug.
6.
Carefully thread the plug into the
engine.
7.
Use the spark plug tool to firmly install
the plug.
8.
Attach the spark plug wire to the plug.
Air Filter
1.
Remove the wing nut holding the air
filter cover to the assembly.
2.
Remove the foam element.
3.
Wash in liquid detergent and water.
Squeeze thoroughly dry in a clean cloth.
4.
Saturate in clean engine oil.
5.
Squeeze in a clean, absorbent cloth to
remove all excess oil.
6.
Place the filter in the assembly.
7.
Reattach the air filter cover and attach
with the wing nut.
Cleaning
CAUTION
DO NOT spray engine with water.
Water can contaminate the fuel system.
Use a damp cloth to clean exterior surfaces
of the engine.
Use a soft bristle brush to remove dirt and
oil.
Use an air compressor (25 PSI) to clear dirt
and debris from the engine.
