100734 - LEAf BLOwER
MAINTENANCE
14
GENERAL TIPS:
–
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
–
Use rakes and brooms to loosen debris before blowing.
–
In dusty conditions, slightly dampen surfaces when water is
available.
–
Hold blower so the air stream can work close to the ground.
–
After using blowers or other equipment, CLEAN UP! Dispose
of debris properly.
wARNING
Never run the unit without the blower tubes installed. Use
of an improperly assembled unit could result in serious
personal injury.
wARNING
Do not place blower on top of or near loose debris or gravel.
Debris may be sucked into blower intake vent resulting
in possible damage to the unit and could result in serious
personal injury.
NOTICE
In some State and local jurisdictions and to comply with local
noise ordinances, operate power equipment during reasonable
hours. For more information, contact your State and local
government for specific requirements.
wARNING
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
Cruise Control feature
The cruise control lever can be used to operate the blower at
desired speed without holding the throttle trigger.
–
To engage, squeeze the throttle trigger and move the cruise
control lever to the desired speed.
–
To release, move the cruise control lever back to the original
low position.
MAINTENANCE
General Maintenance
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use a clean cloth to
remove dirt, dust, lubricant, grease, etc.
wARNING
Before inspecting, cleaning, or servicing the machine, shut
off engine, wait for all moving parts to stop, and disconnect
spark plug wire and move it away from spark plug. Failure
to follow these instructions could result in personal injury or
property damage.
wARNING
When servicing, use only identical replacement parts. Use
of any other parts could create a hazard or cause product
damage.
wARNING
Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact with
plastic parts. Chemicals can damage, weaken, or destroy
plastic which could result in serious personal injury.
wARNING
Tampering or adjusting the factory set carburetor is a
Federal Violation and will void your warranty coverage.
