REV 100133-20141031
12
100133
ENGLISH
ASSEMBLy
Add Engine Oil
Add Engine Oil Cont’d.
1 . Place the log splitter on a fl at, level surface .
2 . Remove oil fi ll cap/dipstick to add oil .
3 . Using a funnel add up to 0 .6 qt . (0 .6 L) of oil and
replace oil fi ll cap/dipstick . DO NOT OVERFILL .
4 . Check engine oil level daily and add as needed .
The engine is equipped with a low oil shut-off
sensor and will stop when the oil level in the
crankcase falls below the threshold level .
CAUTION
Check oil often during the break-in period . Refer to the
Maintenance section for recommended service intervals .
NOTE
The recommended oil type is 10W-30 automotive oil .
NOTE
Synthetic oil may be used after the 5 hour initial
break-in period . Using synthetic oil does not
increase the recommended oil change interval .
NOTE
We consider the fi rst 5 hours of run time to be
the break-in period for the unit . During the break
in period stay at or below 50% of the running
watt rating and vary the load occasionally to allow
stator windings to heat and cool . Adjusting the
load will also cause engine speed to vary and help
seat piston rings . After the 5 hour break-in period,
change the oil .
NOTE
Once oil has been added, a visual check should show
oil about 1-2 threads from running out of the fi ll hole .
If using the dipstick to check oil level, DO NOT screw
in the dipstick while checking .
NOTE
Weather will affect engine oil and engine
performance . Change the type of engine oil used
based on weather conditions to suit the engine
needs .
NOTE
DO NOT attempt to crank or start the engine before
it has been properly fi lled with the recommended
type and amount of oil . Damage to the engine as a
result of failure to follow these instructions will void
your warranty .
CAUTION
Full Synthetic 5W-30
Degrees Celsiusº (Outside)
(Outside)
Degrees Fahrenheitº
