Champion WR1
Radio Programming Guide
Champion Instruments
(678) 386-2208 | www.ChampionInstruments.com
Page
1
/
2
Step
Action
Display
1
In order to configure the Radios in the WR1 receivers you must have the WR1 Radio
Management Software 1.25 or Greater.
*PLEASE NOTE: The FCC requires that you license your UHF radios. That is the user’s responsibility
and not Champion Instruments or its representatives.
2
a) Connect your WR1 receiver to the
computer using the USB cable that came
with the system
.
b) Make sure you have a Full Battery
c)
Power the receiver on
d)
Press the “Power” button to Make Sure it is
in “UHF Rover/Base mode” (if not follow
instruction in the user’s manual)
e)
If you have not previously connected with a
USB cable follow the USB connection
guide
3
a) Run the GM-xxPx Radio Management
1.2.5 or greater Software by double
clicking the install link
b) Select the proper “Com” Port
c) Press the “OPEN” button then
“CONNECT”
d) You will see a Blue Bar across the Bottom
then a message “CONNECT OK”
e) Press “OK”
