First time users
Set up of the Model 7602 MKII
1- Select 40 dB on the
Microphone / Line sensitivity
control. Turn the Output control fully counter
clockwise. Make certain that the
DI, 48V, EQ
and
Phase
switches are all off.
2- Connect a microphone to the Female XLR plug on
the rear panel. If the microphone requires Phantom
Power, switch the
48V
on. The normal position for the
300/1.2K Ohm
switch is 1.2K. This matches most
professional microphones used today; if you have
microphones that require a lower impedance you may
toggle the switch to 300. You can toggle between the
selections without damage to the microphones to
determine which impedance performs better for your
application.
3- Connect the male, Line Output XLR connector,
located on the rear panel to the input XLR on your
recorder or D.A.W.
(If you are sending to a device that does not have a gain
control, use the
Output
control to adjust your signal so
that your loudest signals just fail to reach the maximum
input levels on your recording device.)
10
