CHA F-LOOP
Page 11
Plate 5. High Efficiency Loop Assembly.
80 Meter Conversion Kit Installation
The CHA F-LOOP 80 Meter Conversion Kit allows you to use the CHA F-LOOP on the 80m ham band by extending
the lower frequency range of the Cha F-LOOP down to 3.5 MHz. It is easy to install, simply perform the following
steps. See plate (6) which shows the kit installed on the CHA F-LOOP.
1.
Disconnect one end of the Flexible Radiator
Loop (b) from the Flexible Radiator Loop
Connection (f).
2.
Connect the free end of the Flexible
Radiator Loop to the Loop Extension Barrel
Connector (t).
3.
Connect one end of the Flexible Radiator
Loop Extension (s) to the open Flexible
Radiator Loop Connection from step 1.
4.
Form the Flexible Radiator Loop Extension
into a loop, like the Flexible Radiator Loop.
5.
Attach the top of the Flexible Radiator Loop
Extension to the Faraday Loop (c) using a
Faraday Loop Strap (o).
6.
Connect the free end of the Flexible
Radiator Loop Extension to the open end of
the Loop Extension Barrel Connector.
7.
Set Band Switch (i) to the “A” position.
8.
This completes installation of the 80 Meter
Conversion Kit.
Plate 6. Installed 80 Meter Conversion Kit.