3
CONFIGURATION & DIP SWITCH SETTINGS
24Vac/Vdc
CH1 N/O
CH2 N/O
Delta-3/Linear
Multi-Code
Stanley
DIP
Switches
Configuration
Switch
Channel 2 DIP Switch
Channel 1 DIP Switch
TM
TM
TM
LINEAR
MULTI
STAN
CH1
MODE
CH2
MODE
12V 24V
CST MNT
CST MNT
P3
1
2 3
4 5
6
7 8 9 10
O
N
1
2 3
4 5
6
7 8 9 10
O
N
1
2
3
4
5
6
7
8
9 10
O
N
1
2
3
4
5
6
7
8
9 10
O
N
Figure 4
Figure 2
Multi/ Stanley
(1 Thru 10)
Linear/ Delta-3
(1 Thru 8)
1 2 3 4 5 6 7 8 9 10
O
N
O
F
F
TM
TM
DIP
Switch
Delta-3/ Linear
Multi-Code
Stanley
310 MHz
300 MHz
310 MHz
TM
TM
TM
Configuration
Switch
Setting DIP Switch
The TriCode
®
receiver DIP switch CH1 is factory set OFF (1-10)
and CH2 is factory set ON (1-10).
Locate the 10 position DIP Switch. If this is a new installation
using TriCode
®
transmitters, randomly set switches matching
those of the transmitters. Never use factory setting. If receiver is
used with Linear/Delta-3
TM
, Multi-Code
TM
or Stanley
TM
transmitters,
match the receiver DIP Switch to the above transmitters. Some
transmitters may use toggle switches and it may be difficult to
determine ‘ON’ and ‘OFF’. If so, try reversing the setting on the
TriCode
®
DIP Switch (Figures 3 and 4).
NOTE:
In 'LINEAR/DELTA-3
TM
' mode (8-bits system) the last 2
bits (DIP #9 & 10) settings are ignored. They can be left in either
‘ON’ or ‘OFF’ settings.
Setting the Configuration Switch
The TriCode
®
receiver is factory set for Linear/Delta-3
TM
.
Locate the configuration switch and set it to the desired RF mode
of operation (Figures 2 and 4). Modes are as follows:
Linear/Delta-3
TM
:
works with all “Linear/Delta-3
TM
” transmitters
transmitted at 310 MHz using 8-bits ID system.
Multi
TM
:
works with all “Multi-Code
TM
” transmitters transmitted at
300 MHz using 10-bits ID system.
Stanley
TM
:
works with all “Stanley
TM
radio” transmitters
transmitted at 310 MHz using 10-bits ID system.
Figure 3
Summary of Contents for TRICODE TCG2
Page 5: ......
