Chamberlain RIFMS2 User Manual Download Page 3

Page: 3 / 4

Step 4

Place intercom in frame by inserting top section first,
then snapping the lower section into place.

Step 3

Place the frame in the hole
and tighten screws.

NOTE:

Place frame in wall so

that the two small slots are on
the top and the larger single
slot is on the bottom.

Step 2

Insert a screw into each
hole in the frame and attach
the fasteners. Tighten screw
only 1/4" into the fastener.

Step 1

Cut a hole in the wall measuring 6 1/8" wide by
4 1/2" high.

6 1/8"

4 1/2"

Choose mounting locations where both intercoms will
work when tested.

NOTES:

•

The wall location should be clear of beams and
other obstructions inside the wall.

•

Do not mount intercoms within 6' of each other.

•

Do not mount intercom near any electrical wiring or
electrical devices.

Installation

Summary of Contents for RIFMS2

Page 1: ...amage to the circuit DO NOT use C size Lithium batteries Operation Features Talk Button Talk Button To talk hold down the Talk button All intercoms in the network that are on the same channel will rec...

Page 2: ...hold both buttons on the new intercom for 5 seconds An initial beep will be heard followed by a second beep The channel lights will flash Within 10 seconds put any networked intercom into Learn Mode...

Page 3: ...p 2 Insert a screw into each hole in the frame and attach the fasteners Tighten screw only 1 4 into the fastener Step 1 Cut a hole in the wall measuring 6 1 8 wide by 4 1 2 high 6 1 8 4 1 2 Choose mou...

Page 4: ...ssed or a signal is received Check batteries in Intercom Ensure intercom is connected to a network See Programming Intercom Ensure that intercoms are on the same channel See Operation Features Interco...