16
Programming C840 using the “learn” button:
1. Press and release the “learn” button (1) on opener. The learn
indicator LED will light up.
2. Within 30 seconds, enter a four digit personal identification num-
ber (PIN) of your choice on the keypad (2), then press and hold
the ENTER button.
3. Release the button when the opener courtesy light flashes once
(3). It has learnt the code.
Alternate programming method using the motion detecting
control panel (optional accessory):
NOTE: This method requires two people if the keyless entry is
already mounted outside the garage.
1. Enter a four digit personal identification number (PIN) of your
choice on the keypad, then press and hold ENTER.
2. While holding the ENTER button, press and hold the LIGHT but-
ton on the motion detecting control panel.
3. Continue holding the ENTER and LIGHT buttons while you
press the push bar on the motion detecting control panel (all
three buttons are held).
4. Release buttons when the opener courtesy light flashes once.
25
Programming C379 wireless fingerprint access
system (optional accessory)
Full instructions are available with this accessory.
Once you have enrolled your user into the C379 you can pro-
gram the unit into your opener.
Using the “learn” button:
1. Press and release the “learn” button on the opener. The learn
indicator LED on the opener will light up.
2. Within 30 seconds, slide the cover of the C379 up as illustrated
(A). Swipe your finger on the reader head at a steady speed (B)
until the yellow led turns on (C).
3. When the opener’s courtesy light flashes it has learnt the code.
Ensure there are no obstructions in the path of the door, then
press the send button (D) to test the door.
LIGHT
LOCK
LIGHT
LOCK
1
2
3
1
2
3
4
close
operate
learn
Press and release
the red learn button
open
LED will light up
Courtesy light will
flash once
Release buttons
when light flashes
ENROLL
FAIL
RETRY
SEND
PASS
READY
ENROLL
A
ENROLL
FAIL
RETRY
SEND
PASS
READY
ENROLL
C
B
D
Slide the cover plate
up (A)
Swipe finger at a
steady speed (B)
Yellow LED will indicate
successful swipe (C)
Test reader by pressing
the send button (D)
close
operate
learn
Press and release
the red learn button
open
LED will light up
Courtesy light will
flash once
Enter 4 digit PIN at
keypad (within 30s)
With the LIGHT button
pressed, press and
hold the PUSH BAR on
the motion detecting
control panel
Press and hold down
LIGHT button on the
motion detecting
control panel
Enter 4 digit PIN at
keypad (within 30s)
Activate the opener only when door is in full view,
free of obstruction and properly adjusted. No one
should enter or leave garage while the door is in
motion. Do not allow children to operate push but-
ton(s) or transmitter(s). Do not allow children to play
near the door.
KEYLESS DEVICE PROGRAMMING (OPTIONAL ACCESSORY)
