ADJUSTMENT SECTION
Travel limits regulate the points at which the door will stop
when moving up or down. Follow the steps below to set the
limits.
NOTE: The door must be in the mid or closed position to
begin setting the limits.
TURN POWER ON (The courtesy light will turn on).
Setting the limits :
1. Press and hold the black button (1) until the yellow indicator
light (3) starts flashing slowly then release.
2. Adjust the position of the door to the desired up position by
using the black button. Black moves the door UP (open) and
orange (2) moves the door DOWN (close). Check to be sure
the door opens high enough for your vehicle.
3. Push the remote control (4) or door control. This sets the UP
(open) limit and begins closing the door.
Immediately press either the orange or the black button. The
door will stop.
Adjust the desired DOWN (close) limit position using the
black and orange buttons. Check to be sure the door is fully
closed without applying excessive pressure on the rail (rail
should not bow upwards and the chain/belt should not sag or
droop below the rail). Push the remote control or door
control. This sets the DOWN (close) limit and begins
opening the door.
4. Open and close the door with the remote control or door
control 2 or 3 times. Leave door in the open position ready
for force setting.
NOTE: The force must now be set in order to complete
your installation (refer section 23).
22
The force, as measured on the closing edge of the
door, should not exceed 400N (40kg). If the closing
force is measured to more than 400N, the Protector
System
TM
(IR Beams) must be installed (refer section
26).
The force setting regulates the amount of power
required to open and close the door.
1. Locate the orange button (2).
2. Push the orange button (2) twice to enter unit into force
adjustment mode. The LED (3) (indicator light) will flash
quickly.
3. Push the programmed remote control (1) that was
shipped with your opener. The door will travel to the
DOWN (close) position. Push the remote control (1)
again, the door will travel to the UP (open) position.
The LED (3) (indicator light) will stop flashing when the
force has been learned.
The door must travel through a complete cycle, UP and
DOWN, to ensure the force is set correctly. If the unit
cannot open and close your door fully, inspect your door to
ensure that it is balanced properly and is not sticking or
binding.
23
9
SETTING THE LIMITS
SETTING THE FORCE