2
Program
NOTE:
If the Receiver will be programmed as a GCU
to a Primary Device proceed to "Alternate: Program
as GCU" section. The following steps apply only if the
Receiver will be used by itself.
Step 1:
Ensure the Receiver does not have power
and Dipswitch #1 is set to the
OFF position.
NOTE:
If Receiver is in this
Mode, there can be no other
900 Mhz units in the network.
Step 2:
Connect power (as shown in
Setup: Power
Connections
).
Step 3:
Within 15 seconds, press and hold a button
on a remote control transmitter. The receiver will buzz
indicating programming is successful.
Additional Remote Control Transmitters:
To program additional remote control transmitters,
repeat Step 3 above with each remote control
transmitter (within 10 seconds of each other) or
repeat Steps 1-3.
When all the remote control transmitters have been
programmed, wait 15 seconds for the Receiver to
leave Learn Mode. The Receiver will buzz twice
indicating it is ready for use.
Dipswitch
Time
#8
OFF
0.5 Sec
ON
5 Sec
Channel 4:
NOTE:
These steps apply only if more than one
Receiver is being used.
Step 1:
Ensure the
Receiver does not have
power. Set Dipswitch #1 to
the ON position in each
Receiver.
Step 2:
Select the Identity for the Receiver (set as a
GCU) by changing the Dipswitches as shown in the
chart below.
Receiver ID
Switch #2
Switch #3
2
ON
OFF
3
OFF
ON
4
ON
ON
Alternate: Program as GCU
Dipswitch
Dipswitch
Time
#2
#3
OFF
OFF
0.5 Sec
ON
OFF
5 Sec
OFF
ON
1 Min
ON
ON
Toggle
Channel 3:
Output Timing
Dipswitch
Dipswitch
Time
#4
#5
OFF
OFF
0.5 Sec
ON
OFF
5 Sec
OFF
ON
1 Min
ON
ON
Toggle
Channel 1:
Dipswitch
Dipswitch
Time
#6
#7
OFF
OFF
0.5 Sec
ON
OFF
5 Sec
OFF
ON
1 Min
ON
ON
Toggle
Channel 2:
