2
Installation
Install the door control within sight of the door at a minimum height of 5 feet (1.5 m) where small
children cannot reach, and away from the moving parts of the door. For gang box installations it is not
necessary to drill holes or install the drywall anchors. Use the existing holes in the gang box.
NOTE:
Pre-wiring means that your garage already has wires installed for the door control.
WIRE THE DOOR CONTROL
MOUNT THE DOOR CONTROL
Mark the location of the bottom mounting
hole and drill a 5/32 inch (4 mm) hole.
Install the bottom screw, allowing
1/8 inch (3 mm) to protrude from
the wall.
Position the bottom hole of the door
control over the screw and slide down
into place.
Lift the push bar up and mark the top
hole.
Remove the door control from the wall
and drill a 5/32 inch (4 mm) hole for
the top screw.
Position the bottom hole of the door
control over the screw and slide down
into place. Attach the top screw.
GANG BOX
DRYWALL
6ABx1-1/4"
6-32x1"
HARDWARE
1
2
3
4
5
6
1
2
3
7/16" (11 mm)
Unplug the garage door opener to
prevent the garage door opener from
activating during wiring.
Strip 7/16 inch (11 mm) of insulation
from one end of the wire and separate
the wires.
Connect one wire to each of the two
screws on the back of the door control.
The wires can be connected to either
screw.
PRE-WIRED INSTALLATIONS:
Choose any two
wires to connect, but make note of which wires
are used.
RED
WHITE
WHITE
GREY
WHI
WHITE
E
1
2
3
7/16" (11 mm)
WIRE TO GARAGE DOOR OPENER
Strip 7/16 inch (11 mm) of insulation
from the end of the wire near the garage
door opener.
Connect the wire to the red and white
terminals on the garage door opener.
The wires can be connected to either
terminal.
Reconnect power to the garage door
opener. If the door control has been
installed and wired correctly, a message
will display on the screen. To synchronize
the garage door opener and the door
control, press the push bar up to 3 times,
until the garage door opener activates.
The time and temperature will display on
the door control when the door control
and the garage door opener are
synchronized.
PRE-WIRED INSTALLATIONS:
Connect the same
wires to the garage door opener that were
previously connected to the door control.
To insert or release wire, push
in tab with screwdriver tip.
Drywall Anchors
Close the push bar.
7
1
2
3
4
5
6
7
