Page 9
Wiring 1 Unit to Telco Line
Wiring 1 Unit to Telco Line
The bypass board allows the unit to be disconnected without interrupting normal telephone operation.
NOTE:
Installation where fiber optic phone lines are present may require additional modifications from your
telephone provider. Contact your provider for more information.
• When the unit is
in use
, the bypass switch must be set to the
operate
position.
• When the unit is
disconnected
, the bypass switch must be set to the
bypass
position.
Tip
Ring
Tip
Ring
OPERATE
BYPASS
Ring
HOME
Tip
Ring
TELCO
Tip
SYSTEM
Bypass Board
(Mount in the House)
(NOT Provided)
Ring
Tip
Ring
Tip
Home Phone
Alarm System Position
Use 18-24 AWG
2 twisted pair
NOTE:
If the unit will be used in
conjunction with an alarm system, you
MUST
connect the telephone line to the
alarm system first. If the units are not
connected in this order, they will not
operate properly.
4
4 3 2 1
3
2
1
Output Board
(See page 6)
Telco Entrance Box
Demarcation Point
DO NOT
overload the removable
terminal block connectors. One
wire per hole.
IMPORTANT:
The Bypass
Board (located inside the
property) allows access to
the phone in case the unit
fails.
Never
run
Telco wires
and
High
Voltage wires
in the
same
conduit. The high voltage wires
may interfere with the Telco
wires, possibly causing the
system to malfunction.
RES
TELCO
